Progressive failure of asphalt shingles under high winds: Assessment via full-field deformation measurements on full-scale roof panels

Abstract

Failures of roof asphalt shingles under high winds have been reported to occur at wind speeds lower than the shingle performance classification. The understanding of the progressive failure mechanisms of shingles subjected to high-wind pressures has been hindered by difficulty in accurately quantifying uplifts and wind-induced pressures with high spatial resolution, especially for large-scale wind test setups that simulate realistic scenarios. This paper reports on an experimental study to assess the use of three-dimensional digital image correlation (‘StereoDIC’) to accurately measure full-field surface deformations of shingles installed on full-scale roof structures and subjected to realistic high winds. Deformation measurements were acquired on shingles installed on typical wood-frame roof panels and subjected to winds with speed up to 257 km/h (160 mph) using an outdoor wind tunnel. The specimens were designed to study the proposed test setup and StereoDIC measurement method for two different combinations of shingle surface coloration (and thus speckle pattern) and field of view. The experiments produced accurate local and full-field shingle deformation measurements. Different datasets were used to gain new insight into the influence of salient aspects of the wind test setup and deformation measurement method on the understanding of the temporal evolution of shingle uplift and failure mechanisms.