Progress of the ECHo SDR Readout Hardware for Multiplexed MMCs

Abstract

The electron capture in ^{163}Holmium (ECHo) experiment seeks to achieve sub-eV sensitivity of the electron neutrino mass through calorimetric decay spectroscopy of ^{163}Ho in large arrays of cryogenic magnetic microcalorimeters (MMCs). Microwave SQUID multiplexing serves to efficiently increase the number of readout channels, thus calorimeters per array and ultimately per cryostat. A corresponding frequency multiplexing room temperature software-defined radio (SDR) system is in development to enable the readout of this increased number of MMCs per cable. The SDR consists of a custom FPGA platform that provides signal generation and analysis capabilities, as well as tailored signal conversion and analog conditioning front end electronics that enable the room-temperature-to-cryogenic interface. Ultimately, the system will read out 400 multiplexer channels with double pixel detectors through a bandwidth of 4 GHz (IEEE C band). As high-resolution data converters are limited in sample rate, the C-band is split into five sub-bands using a two-stage mixing method. In this contribution, a prototype of the heterodyne RF design is presented. It comprises one of the five 800 MHz sub-bands for a target frequency range between 4 and 8 GHz. Furthermore, the second version of the A/D converter stage is presented, capable of generating and digitizing up to five complex basebands using 1 GSs^{-1} converters, the reference clocks and a flux-ramp signal. We will show first results of their single and combined characterization in the lab. The current state of the prototype hardware enables preliminary measurements, only limited in bandwidth and with slightly higher noise. Potential improvements could be derived and will be implemented in the full bandwidth, 5-sub-band RF PCB design.