Abstract
This paper deals with the grinding characteristics of newly developed ultrafine-crystalline cBN (cBN-U) abrasive grains in creep feed profile grinding of high-speed steels. Experiments for producing a V-shaped groove on a flat surface in one pass by creep feed grinding have been carried out using new polycrystalline cBN-U and representative conventional cBN (cBN-B) abrasive grains. When grinding with the cBN-U wheel, both radial wear and profile wear are less, and hence the grinding ratio is around 4 times higher than that with conventional cBN-B wheel. Grinding force in grinding with the cBN-U wheel is reduced by 5∼15 % compared with that in grinding with the cBN-B wheel. The cBN-U abrasive grain is suitable for application with a high dimensional accuracy in creep feed profile grinding for high-speed steel, because it gives less profile wear, and hence better form retention of the wheel, than conventional cBN abrasive grain.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Advanced Mechanical Design, Systems, and Manufacturing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
