Abstract
The submicroparticles of β-sitosterol were produced by using an aerosol solvent extraction system (ASES) and characterized by scanning electronic microscope (SEM), X-ray diffraction (XRD), and Fourier transform infrared (FT-IR) analysis. The effects of operational parameters including pressure, temperature, solution concentration, and ratio of flow rate (CO 2/solution, r) on particle size (PS), yield, and morphology were investigated. The results showed that microparticles of β-sitosterol (less than 1000 nm size and larger than 70% yield) could be obtained at 10-15 MPa, 35–50°C, 15 mg·ml −1, 10/1( r); β-sitosterol particles were found to occur as three mophologies: flakes, rods, and spheres by varying ratio of flow rate or solution concentration. In contrast, the crystallinity of β-sitosterol decreased, whereas its molecular structure remained almost unchanged after being ASES-treated. Therefore, ASES was an effective method to produce submicroparticles of β-sitosterol.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
