Production of omega 3-rich oils from underutilized chia seeds. Comparison between supercritical fluid and pressurized liquid extraction methods

Abstract

Chia seeds constitute a promising source of α-linolenic acid (ALA). In the present work, an underutilized and cheaper set of chia seeds, which were discarded after the harvest according to quality criteria - named in this work as low oil content seeds (LOCS) - have been evaluated as a potential source for obtaining PUFA-enriched oils against the commonly studied high-quality chia seeds denoted as high oil content seeds (HOCS) in this study. Two efficient and environmental friendly techniques, supercritical fluid extraction (SFE) and pressurized liquid extraction (PLE), were evaluated to optimize the extraction process of chia oil. At 60 °C, by using pressurized food-grade ethanol, recoveries close to 100% were achieved from both sets of seeds in a short extraction time (10 min). By using SFE, the greatest oil extraction yield (>95%) was attained at the highest pressure and temperature conditions (45 MPa and 60 °C) after 240 min. At the early stage of SFE extraction, both LOCS and HOCS exhibited a similar kinetic behavior, reaching oil extraction rates of 0.59 g oil/min and 0.64 g oil/min, respectively. No differences were found between the fatty acid profile of the oils extracted from LOCS and HOCS both by PLE and SFE. ALA and linoleic acid (LA) concentrations ranged between 65‐68% and 17–23% respectively, and a predominance of high molecular weight triglycerides (≥ CN50), was found in all extracted oils. In conclusion, LOCS might constitute a new suitable raw material for the production of ALA-enriched oils. Concerning the extraction methods assayed, the oil was almost entirely recovered by both PLE and SFE at the used conditions.