Abstract
The alpha emitter astatine-211 (211At) is garnering attention as a novel targeted alpha therapy for patients with refractory thyroid cancer resistant to conventional therapy using beta emitter radioiodine (131I). Herein, we aimed to establish a robust method for the manufacturing and quality control of [211At]NaAt solution for intravenous administration under the good manufacturing practice guidelines for investigational products to conduct an investigator-initiated clinical trial. 211At was separated and purified via dry distillation using irradiated Bi plates containing 211At obtained by the nuclear reaction of 209Bi(4He, 2n)211At. After purification, the 211At trapped in the cold trap was collected in a reaction vessel using 15 mL recovery solution (1% ascorbic acid and 2.3% sodium hydrogen carbonate). After stirring the 211At solution for 1h inside a closed system, the reaction solution was passed through a sterile 0.22μm filter placed in a Grade A controlled area and collected in a product vial to prepare the [211At]NaAt solution. According to the 3-lot tests, decay collected radioactivity and radiochemical yield of [211At]NaAt were 78.8 ± 6.0 MBq and 40 ± 3%, respectively. The radiochemical purity of [211At]At- obtained via ion-pair chromatography at the end of synthesis (EOS) was 97 ± 1%, and remained > 96% 6h after EOS; it was detected at a retention time (RT) 3.2-3.3min + RT of I-. LC-MS analysis indicated that this principal peak corresponded with an astatide ion (m/z = 210.988046). In gamma-ray spectrometry, the 211At-related peaks were identified (X-ray: 76.9, 79.3, 89.3, 89.8, and 92.3keV; γ-ray: 569.7 and 687.0keV), whereas the peak at 245.31keV derived from 210At was not detected during the 22h continuous measurement. The target material, Bi, was below the 9 ng/mL detection limit in all lots of the finished product. The pH of the [211At]NaAt solution was 7.9-8.6; the concentration of ascorbic acid was 9-10mg/mL. Other quality control tests, including endotoxin and sterility tests, confirmed that the [211At]NaAt solution met all quality standards. We successfully established a stable method of [211At]NaAt solution that can be administered to humans intravenously as an investigational product.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.