Abstract
Abstract In this study, low superheat casting and cooling slope casting processes were carried out with A356 and A380 aluminum alloys in order to obtain feedstocks with near globular microstructures. Castings were conducted at 20 °C above of the liquidus temperature for both processes and molten alloys were cast through a copper cooling slope with two different lengths (350 mm and 650 mm) and two different tilt angles (30° and 60°). In order to evaluate the significance of boron nitride coating on cooling slope, castings in short slope were carried out under both coated and uncoated conditions. Microstructural examinations and hardness measurements were carried out. According to obtained results, cooling slope casting caused superior microstructural properties as compared to low superheat casting, especially for A356 alloy. 30° tilt angle was found more efficient in order to obtain a more globular microstructure for A356, while, on the other hand, the tilt angle of 60° was detected more favorable in that manner for A380. Obtained grain size measurements were slightly improved with the employment of short slope and coating was found beneficial especially for A356 alloy. The measured hardness values did not display any significant difference in the same alloy type except in the low superheat cast A356 specimen, which was obtained with coarser microstructure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.