Abstract
In order to get high precision balls used in oil exactor, Eccentric dual-rotating (EDR) V-groove lapping mode and Rotated dual-plates (RDP) lapping mode are applied for the batch processing of WC-Co cemented carbide balls of Φ35mm. After comparing two innovated modes, firstly EDR V-groove lapping mode is used in rough lapping stage for high efficiency, and then semi-finishing lapping stage, finishing lapping stage and polishing stage are carried out by RDP lapping mode. Through changing the processing parameters legitimately, including abrasive grain, adjustable rotating velocity and load, the rational course and parameters are defined, and WC-Co cemented carbide balls of Φ35mm satisfy the end products’ demand which means the sphericity is less than 1μm and the roughness of surface (Ra) is better than 50nm, so these balls can be applied in one-way hydraulic value used in oil exactor.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
