Abstract
The restoration of ancient ceramics has attracted widespread attention as it can reveal the overall appearance of ancient ceramics as well as the original information and artistic charm of cultural relics. However, traditional manual restoration is constrained due to its time-consuming nature and susceptibility to damaging ancient ceramics. Herein, a three-dimensional (3D) printing technique was employed to accurately restore Chinese Yuan Dynasty Longquan celadon using hollow Al2O3 microsphere-modified 3D printing paste. The results show that the hollow Al2O3 microsphere content plays a vital role in the printability, physical properties, and firing performance of the modified 3D printing paste. The printed green bodies show no noticeable spacing or voids under moderate rheological conditions. The as-prepared ceramic body modified with 6 wt.% hollow Al2O3 microspheres and fired at 1280 °C exhibits optimal bending strength of 56.66 MPa and a relatively low density of 2.16 g∙cm-3, as well as a relatively uniform longitudinal elastic modulus and hardness along the interlayer. This 3D printing technique based on hollow Al2O3 microsphere-modified paste presents a promising pathway for achieving non-contact and damage-free restoration of cultural relics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.