Processing maps for hot working of FeAl-based alloy

Abstract

Processing and instability maps for hot working of an FeAl-based intermetallic alloy (Fe-36Al-0.22Mo-0.05Zr-0.01B at. %) have been studied using compression tests in the temperature range 600–1200 °C and in the strain rate range 10 −3–10 2 s −1. The processing maps were calculated to evaluate the efficiency of hot deformation and to identify the instability zones of the flow. The isothermal, constant-strain rate compression tests were carried out on a Gleeble 3800 testing system. The flow stress was found to be strongly dependent on temperature and strain rate. At higher strain rates or lower temperatures, the FeAl-based alloy exhibited a flow-softening type of stress–strain curve, while at lower strain rates or at higher temperatures, the flow curves were of a steady-state type. The optimal hot-working conditions for the investigated FeAl alloy were in the temperature range 1000–1100 °C and at strain rates 10 −2–1 s −1, since the material exhibited dynamic recrystallization to produce a fine-grained structure ( d eq ∼ 120 μm). In the temperature range 800–1000 °C with a low strain rate (<10 −2 s −1), the material underwent strong dynamic recovery and recrystallization simultaneously, which suggests the occurrence of coarse-grained superplasticity. An increase in strain from 0.2 to 0.6 negligibly enlarged the optimal hot-working domain.