Abstract
This article investigates the fabrication of functionally graded materials (FGMs) by selective laser sintering (SLS) of Nylon-11 composites filled with different volume fractions of glass beads (0–30%). The investigation involved a combination of experimental studies, theoretical modeling and numerical analysis. Optimal processing parameters for each composition were developed by design of experiments (DOE). These parameters were then compared with parameters predicted by numerical modeling. Specimens for tensile and compressive testing for each composition and for a 1D FGM composition were fabricated and tested. The experimentally measured tensile and compressive moduli were compared with moduli predicted by Halpin's theoretical model and were found to be in excellent agreement. The results showed that the tensile and compressive modulus increases while strain at break and strain at yield decreases as a function of glass bead volume fraction. A finite element model for the compressive properties of the 1D FGM specimen showed good agreement with experimentally measured values. Finally, to demonstrate the SLS-based FGM approach, two components exhibiting a one-dimensional functional gradient of particulate-filled polymer composites were fabricated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
