Abstract
AbstractBlends of PEI with an amorphous copolyester (PCTG) were obtained by melt‐mixing followed by injection molding. The processability of PEI increased several times upon addition of just 10% PCTG, thus expanding the applications of PEI. All the blends showed a single Tg and most of them were transparent. However, they were biphasic as suggested by the widening of the Tg's and proved by SEM. A fine dispersed particle size and good adhesion level were also observed by SEM. The values of the modulus of elasticity and the yield stress appeared close the additivity rule, and were attributed to the combined effects of the density increase and orientation decrease in the blends. These morphological changes had a slightly negative influence on ductility which was nevertheless high.magnified image
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
