Abstract
PurposeThe purpose of this paper is to investigate the accuracy and repeatability of the indirect selective laser sintering of aluminium process.Design/methodology/approachThis work characterised the shrinkage of indirect SLS aluminium parts during the various stages of production. Standard scale parts were measured using a Giddings and Lewis co‐ordinate measuring machine in both the green and infiltrated condition.FindingsThe experiments conducted show that most accuracy is lost during the furnace cycle and that the greatest loss of accuracy occurred in the Z dimension. Additionally the position of parts within the part bed in both X, Y and Z is shown to influence accuracy, with smaller parts being built closer to the edge of the bed later in the build. These results have been interpreted as being a result of the phenomenon of “Z‐growth”. Finally, the research shows that the overall accuracy of the indirect selective laser sintering of aluminium process is comparable with many existing processes such as investment casting.Originality/valueBefore any new material can be accepted, there is a need to not only fully characterise the dimensional accuracy attainable, but also to gain a thorough understanding of the processes that contribute to the inaccuracies. This paper addresses this need.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
