Abstract
The forming scheme of a side-plate of the core part in parallel flow evaporator was studied. Two forming schemes were compared and the explicit dynamic software DYNAFORM was applied to make simulations about the forming processes. According to comparisons between two forming schemes, the optimized scheme and process parameters were determined. Multi-station dies were designed based on the optimized process. Successful experiments with the dies showed that numerical simulation provided an efficient way for the optimization of the forming scheme in the side-plate production.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
