Process characterization and influence of alternative carbon sources and carbon-to-nitrogen ratio on organic acid production by Aspergillus oryzae DSM1863

Abstract

L-Malic acid and fumaric acid are C4 dicarboxylic organic acids and considered as promising chemical building blocks. They can be applied as food preservatives and acidulants in rust removal and as polymerization starter units. Molds of the genus Aspergillus are able to produce malic acid in large quantities from glucose and other carbon sources. In order to enhance the production potential of Aspergillus oryzae DSM 1863, production and consumption rates in an established bioreactor batch-process based on glucose were determined. At 35 °C, up to 42 g/L malic acid was produced in a 168-h batch process with fumaric acid as a by-product. In prolonged shaking flask experiments (353 h), the suitability of the alternative carbon sources xylose and glycerol at a carbon-to-nitrogen (C/N) ratio of 200:1 and the influence of different C/N ratios in glucose cultivations were tested. When using glucose, 58.2 g/L malic acid and 4.2 g/L fumaric acid were produced. When applying xylose or glycerol, both organic acids are produced but the formation of malic acid decreased to 45.4 and 39.4 g/L, respectively. Whereas the fumaric acid concentration was not significantly altered when cultivating with xylose (4.5 g/L), it is clearly enhanced by using glycerol (9.3 g/L). When using glucose as a carbon source, an increase or decrease of the C/N ratio did not influence malic acid production but had an enormous influence on fumaric acid production. The highest fumaric acid concentrations were determined at the highest C/N ratio (300:1, 8.44 g/L) and lowest at the lowest C/N ratio (100:1, 0.7 g/L).