Abstract
Due to their good mechanical properties and low structural weight, multi-material structures are a promising approach in the automotive industry to lightweight design, body construction and functionalization. Especially metal and plastic are mainly combined to achieve improved properties of the final component compared to mono-material structures. This paper describes the development of a manufacturing cell for the joint forming and heat-assisted press joining of steels and continuous fiber-reinforced thermoplastics in the form of unidirectional carbon-fiber tapes. In order to achieve shorter cycle times and to ensure economical production, a manufacturing cell, supplemented with automated handling by means of two robots and an isothermal, two forming stages tool concept was developed and tested. The composite components produced were tested with regard to their mechanical performance. The feasibility of the production was demonstrated. All composite components had a higher specific load capacity than a pure steel component. Cycle times of well under 60 seconds were achieved. An enormous reduction in process time compared to variothermal tool concepts could be achieved with the new manufacturing cell.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.