Abstract
This article uses minimum quantity lubrication technology to replace traditional machining. A mixed nanofluid cutting fluid MNFCF was prepared using base oil, LINN4444 ionic liquid, and nanoparticles as raw materials, and its tribological and drilling properties were studied. In the tribological performance test, the friction coefficient of the mixed nanofluid MNFCF is only 0.13. Compared with the control, the wear amount of MNFCF has decreased by about 75%, indicating that MNFCF has good anti friction and wear performance. Similarly, in the drilling performance test, the drilling test temperature of MNFCF cutting fluid decreased by 36.5% compared to the same. After drilling and testing, there was almost no BUE, BUL, or wear on the surface of the tool, with only a small amount of adhesive observed. The results indicate that MNFCF has good potential in drilling Inconel 690 high-temperature alloy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
