Probing of crack breathing by pulsed laser-generated acoustic waves

Abstract

Experimental results on all-optical monitoring of the nonlinear motion of a surface-breaking crack are reported. Crack closing is induced by quasi-continuous laser heating, while Rayleigh surface acoustic pulses and bulk longitudinal surface skimming pulses are also generated and detected by lasers. By exploiting the strong dependence of the acoustic pulses reflection and transmission efficiency on the state - open or closed - of the contacts between the crack faces, the parametric modulation of ultrasonic pulses is achieved. It is observed that bulk acoustic waves, skimming along the surface can be more sensitive to crack motion than Rayleigh surface waves. It has been found that crack closure by thermo-elastic stresses modifies the propagation paths of the acoustic rays from the point source to the point receiver. Consequently, the arrival times of the acoustic waves contain information on the state of crack closure induced by a particular intensity of laser heating. A dependence of the detected signals on the initial width/state of the crack and on the presence of necks in the crack opening profile is revealed. The mode conversion of the skimming longitudinal bulk waves incident on the crack into Rayleigh waves is found very sensitive to imperfectness of crack closure.