Abstract
Printed thermoelectric generators (TEGs) show promising potential for converting waste heat into useful electricity at a low cost but fall short of exhibiting a conversion efficiency anticipated from materials’ properties. The output power of conventionally printed TEGs in the “π‐type” geometry suffers due to low thermal voltage and low current because of high thermal and electrical contact resistance, respectively. Herein, a type of printed p–n junction TEGs (PN‐TEGs) as a possible remedy is explored. Two printed PN‐TEGs with different thicknesses are fabricated using printed p‐type Bi0.5Sb1.5Te3 and n‐type Bi2Te2.7Se0.3 materials. The PN‐TEGs show a promising way to minimize the influence of thermal and electrical resistance in printed TEGs. In the experimental and simulation results, the significant impact of PN‐TEGs’ dimensions on their power outputs is revealed. Also, a conventional “π‐type” printed TEG is fabricated and its performance is studied. The optimized PN‐TEG with a single thermocouple yields ≈14 times higher power output density of 5.3 μW cm−2 at a ΔT of 25 K compared to “π‐type” printed TEGs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
