Abstract
Based on the analysis of formation and variation characteristics of oxide layers in ELID grinding, a new measurement principle and method for oxide layer measurement in ELID grinding was proposed. The thickness of the oxide layer was obtained based on measurement both outside surface and inner surface of the oxide layer by laser sensor and eddy current sensor. Calculation methods for measurement of the oxide layer in different ELID grinding periods were presented. In order to verify the correctness of the measurement principle and measurement method, evaluation experiments were down. Results show that the precision of the measurement is sufficient to be applied in ELID grinding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.