Primary Creep and Stress Relaxation Behavior Modeling of a Steel for Turbine Applications

Abstract

Abstract A constitutive equation, with parameters derived from the interpolation of primary and steady state stages of constant load creep curves, has been utilized to estimate the stress relaxation behavior of the martensitic steel X20Cr13, alloy used in many high temperature applications, including heavy duty gas turbines. Creep and stress relaxation tests have been performed at 350°C, close to the negligible creep temperature of the studied alloy for stresses of interest for engineering applications. The creep tests were carried out at stresses below and above the yield stress, whereas, for the relaxation stress tests, the imposed strain was in the range 0.2% to 1.2% with the purpose to have, at the beginning of the tests, the same initial stresses of the performed creep tests. After a stress relaxation period, lasting between 10 to 1000 hours, each specimen was generally reloaded at the initial stress and a new relaxation test, on the same specimen, was carried out. This “reloading procedure”, simulating the re-tightening of bolts, has been repeated several times. The proposed equation has shown to well predict the experimental creep and stress relaxation behavior of the steel under investigation.