Abstract
Since mid 1999 MBR technology is introduced into domestic wastewater treatment in Germany. First wwtps went in operation performing a conventional mechanical treatment (covering screens, grit chambers and grease traps) without any advanced mechanical pre-treatment stage. After a short operation period module-clogging and hence module sludging was observed. Thus, mechanical pre-treatment was upgraded introducing sieves, first of all to reduce hairs and fibrous substances. But today knowledge is relatively poor concerning effectiveness and treatment efficiency of the whole bunch of aggregates that had been brought to market and vary e.g. in gap size and gap geometry. This paper gives the basics of sieving, the current status of mechanical pre-treatment on German municipal MBR plants and exemplifies an investigation to determine treatment efficiency of two different sieve aggregates.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.