Abstract
Pressureless sintering of SiC‐whisker‐reinforced Al2O3 composites was investigated. In Part II of the study, the effects of Y2O3/MgO sintering additives and green body infiltration on densification behavior and microstructure development are reported. Both sintering additives and green body infiltration resulted in enhanced densification. However, the infiltration approach was more effective for samples with high SiC whisker concentrations. Samples with 27 vol% whiskers could be pressureless sintered to ∼93% relative density and ∼3% open porosity. Fracture toughness values and microstructural features (e.g., grain size) for the infiltrated samples remained approximately the same as observed in the uninfiltrated samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
