Pressure-induced Shape Change of Phospholipid Vesicles: Implication of Compression and Phase Transition

Abstract

A microscopic study has allowed the analysis of modifications of various shapes acquired by phospholipid vesicles during a hydrostatic pressure treatment of up to 300 MPa. Giant vesicles of dimyristoylphosphatidylcholine / phosphatidylserine (DMPC/PS) prepared at 40 degrees C mainly presented a shape change resembling budding during pressure release. This comportment was reinforced by the incorporation of 1,2-dioleyl-sn-glycero-3-phosphatidylethanolamine (DOPE) or by higher temperature (60 degrees C) processing. The thermotropic main phase transition (L alpha to P beta') of the different vesicles prepared was determined under pressure through a spectrofluorimetric study of 6-dodecanoyl-2-dimethylamino-naphtalene (Laurdan) incorporated into the vesicles' bilayer. This analysis was performed by microfluorescence observation of single vesicles. The phase transition was found to begin at about 80 MPa and 120 MPa for DMPC/PS vesicles at, respectively, 40 degrees C and 60 degrees C. At 60 degrees C the liquid-to-gel transition phase was not complete within 250 MPa. Addition of DMPE at 40 degrees C does not significantly shift the onset boundary of the phase transition but extends the transition region. At 40 degrees C, the gel phase was obtained at, respectively, 110 MPa and 160 MPa for DMPC/PS and DMPC/PS/DOPE vesicles. In comparing volume data obtained from image analysis and Laurdan signal, we assume the shape change is a consequence of the difference between lateral compressibility of the membrane and bulk water. The phase transition contributes to the membrane compression but seems not necessary to induce shape change of vesicles. The high compressibility of the L alpha phase at 60 degrees C allows induction on DMPC/PS vesicles of a morphological transition without phase change.