Pressure drop and friction factor of steady and oscillating flows in open-cell porous media

Abstract

Open-cell metal foams are often used in heat exchangers and absorption equipment because they exhibit large specific surface area and present tortuous coolant flow paths. However, published research works on the characteristics of fluid flow in metal foams are relatively scarce, especially for the flow oscillation condition. The present experimental investigation attempts to uncover the behavior of steady and oscillating flows through metal foams with a tetrakaidecahedron structure. In the experiments, steady flow was supplied by an auto-balance compressor and flow oscillation was provided by an oscillating flow generator. The pressure drop and velocity were measured by the differential pressure transducer and hot-wire sensor, respectively. The friction factor of steady flow in metal foam channel was analyzed through the permeability and inertia coefficient of the porous medium. The results show that flow resistance in the metal foams increases with increasing form coefficient and decreasing permeability. The empirical equation obtained by the present study indicates that the maximum friction factor of oscillating flow through the tested aluminum foams with specific structure is governed by the hydraulic ligament diameter-based kinetic Reynolds number and the dimensionless flow amplitude.