Abstract

Simple SummaryRed deer (Cervus elaphus) are farmed in New Zealand for the production of velvet antler. Velvet is harvested as living antler tissue, and currently lignocaine is the only licensed local anaesthetic approved for deer antler removal in New Zealand. The use of lignocaine is not without consequences, including drug residues in harvested velvet antler tissue and its short acting analgesic effect. This study was designed to determine the effect of local anaesthetic, articaine hydrochloride as an alternative treatment and to establish the baseline measurements of mechanical nociceptive threshold in 40 male yearling red deer. Ten of the forty enrolled deer were selected for the articaine efficacy study. The mechanical nociceptive thresholds were measured using a handheld algometer applied at 4 points; the cranial, medial, caudal and lateral aspects of the base of each antler. The force applied, which resulted in a movement by the animal, was recorded in newtons (N). This study showed that nociceptive threshold response in deer could be reliably measured, and articaine proved to be a promising alternative for velveting the deer antlers.New Zealand deer farming centres on the production of meat and velvet antler. Velvet antler removal is a painful procedure and currently, New Zealand Animal Welfare regulations dictate surgical removal of velvet antlers under lignocaine anaesthesia. To improve our knowledge on the efficacy and duration of other local anaesthetics to mitigate pain after antler removal, it is important to accurately assess and quantify pain arising from antler removal. Therefore, the current study was designed to validate mechanical nociceptive threshold (MNT) testing using a Wagner hand-held algometer, and to apply this methodology to assess the efficacy and duration of action of articaine for antler removal in deer. Baseline force (N) required to elicit the nociceptive response was recorded in 40 yearling male red deer on three alternate days. Ten of the 40 animals were selected for antler removal after administration of 4% articaine hydrochloride as a ring block. The duration of analgesic efficacy of articaine was assessed by algometry across 5 time points. There was a significant difference in MNTs among the three days (day 3 versus day 1 (p < 0.0001), day 2 versus day 1 (p < 0.0001), and day 1 versus day 2 (p < 0.01)). Positive correlations were observed between weight, antler length and thresholds. The MNT values remained above 20N for 6 h after removal of velvet antlers under the articaine ring block. This study provides valuable information about the use of MNT in red deer. These findings lay a foundation for future studies in the topics of peri-operative and postoperative pain management in deer antler removal, and a possible alternative use for articaine.

Highlights

  • Pain assessment related to deer antler removal was assessed by both behavioural and physiological measurements [1]

  • All forty animals enrolled were used in the study, and none of the animals were excluded for injury, discomfort, disease or no response to the nociceptive threshold assessment

  • All ten animals that were selected for analgesia with articaine hydrochloride (4%), showed no side-effects or reactions followed by the treatments

Read more

Summary

Introduction

Pain assessment related to deer antler removal was assessed by both behavioural and physiological measurements [1]. There were no differences in cortisol levels in the deer, which had antlers removed with analgesics compared to those removed without any analgesia [3], probably due to handling stress or isolation during the procedure [3]. Physiological parameters such as heart rate can be an indicator of stress; it increased following antler removal [4] but was found to be an unreliable measurement for pain assessment. Deer, being a prey species, evolved to not exhibit the visible signs of pain [7]

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call