Press-fit reverse shoulder arthroplasty in case of advanced humeral bone loss – Is additional distal fixation necessary for primary stability?

Abstract

BackgroundRevision reverse shoulder arthroplasty (RSA) poses considerable surgical challenges. We hypothesized that a newly developed press-fit stem, which is modeled on the medullary canal of the supracondylar region of the distal humerus by a slight distal bend, achieve both correct fit and sufficient primary stability and that additional distal fixation by interlocking screws is favorable in case of advanced humeral bone loss. MethodsA modular tapered press-fit stem was implanted in 16 Sawbone humeri in three consecutively created defect situations (200 mm (experimental group type 3°), 160 mm (type 4°) and 120 mm (type 5°) bone length above the epicondylar line. In experimental groups type 4° and 5°, additional distal interlocking screw fixation with one to three screws was tested. Primary stability was investigated by measuring micromotions with a high-precision rotational setup. FindingsHighest relative micromotions were noted at the proximal end in experimental groups type 3° and type 4°, whereas in type 5° highest micromotions could be seen at the distal end. Overall micromotions were significantly lower in type 3° and increased with extended defect size. In experimental group type 5°, micromotions increased with reduced additional distal screw fixation. InterpretationThe examined press-fit stem did not provide sufficient primary rotational stability in all constructs without additional support. Advanced distal humeral bone loss had a strong impact on primary fixation. In experimental group type 5° with 120 mm bone remaining, it might be beneficial to use three distal interlocking screws in the supracondylar region in order to neutralize torque and to avoid early loosening.