Preparing DNA SAM Electrochemical Sensors Using Potential Assisted Deposition Methods. Controlling the Coverage and Local Organization of the DNA in the SAM.

Abstract

Typically, DNA SAMs used for electrochemical based sensing are prepared without controlling the gold electrode potential[1]. Applying a potential during DNA deposition enables control over the coverage and DNA organization[2-4]. These characteristics are determined by the composition of the immobilization buffer, the immersion time, the DNA concentration, the extent of backfilling with a small alkylthiol and whether deposition occurs on a bare or alkythiol coverage gold surface[3-4]. Few studies have explored the influence of the underlying surface crystallography. Here, we show the possibilities of using electrochemical potential control to manipulate the characteristics of the DNA SAM. Moreover, the use of a single crystal gold bead electrode, coupled with the use of a fluorophore tagged DNA and fluorescence microscopy, enables examination of the influence of the underlying surface crystallography on the DNA SAM prepared. Various constant potentials were used as well as using a square-wave potential perturbation during deposition. There are significant differences in the DNA SAM produced under these conditions. In some cases, the DNA coverage was low on the <111> surfaces, higher on more open or atomically rough regions. In other cases, the coverage was higher on the <100> surfaces as compared to the other regions. The use of constant positive or negative potentials (vs SCE) resulted in significant differences in the relative coverages among regions of different atomic arrangements (Fig 1). In addition, a significant difference was observed between immobilization buffers that contain Cl and those that are Cl free. Also, the use of constant or square-wave potential perturbations resulted in significantly different local organizations of DNA in the SAM. Examples of these types of DNA SAM surfaces will be presented with some conclusions on the implications for use on polycrystalline planar gold surfaces.