Preparation of PVDF-nSiO2/PVSQ high-flux composite membrane by chemical grafting and separation of composite brine by membrane distillation

Abstract

The large-scale application of membrane distillation (MD), an important method for desalting seawater, is limited due to membrane fouling. In this study, ethyl orthosilicate (TEOS) was polymerized to obtain different nSiO2 particles. Vinyl triethoxysilane (VTES) was hydrolysed and polycondensation was used to produce spherical polyethylene-sesquioxane (PVSQ) microparticles, which were modified to construct micro/nano particles. Then grafted on the surface of polyvinylidene fluoride (PVDF) composite membrane. The low-surface-energy hydrophobic groups present on the surfaces of the vinyl and ethoxy particles greatly enhanced the membrane hydrophobicity. The particle size of nSiO2 can change the properties of the membrane. The separation performance of the membrane was tested by direct contact membrane distillation (DCMD). In the separation of a constant concentration of feed solution (3.5 wt% NaCl), the membrane flux was relatively stable at 23.8 kg·m−2·h−1, and the salt interception rate reached 99.99 %. In the subsequent separation of a salt/humic acid solution, the flux remained stable and the good anti-fouling performance indicating that this system outperformed the unmodified membrane. Finally, the effect of different cations on the water diffusivity was studied using a molecular simulation method. Both Ca2+ and Mg2+ reduced the diffusion coefficient of water. However, when these two ions were present simultaneously, Ca2+ inhibited the binding of Mg2+ to water, and the diffusion coefficient of water increased. This study provides a novel approach for preparing hydrophobic membranes for the separation of complex brines.