Preparation of nitrogen-doped carbon pyrolyzed from ZIF-8 and its performance in electrocatalytic oxygen reduction to hydrogen peroxide

Abstract

As an environment-friendly strategy, electrocatalytic hydrogen peroxide (H2O2) generation via two-electron oxygen reduction reaction (2e– ORR) has attracted significant scientific and technological attention. Nevertheless, limited to the low catalytic activity and high cost of noble metal-containing catalysts, forging desired electrocatalysts with high catalytic activity, low cost, and sustainability is still challenging. In this work, nitrogen doped porous carbon materials named p-ZIF-800 and p-ZIF-950 were obtained by pyrolysis of zeolitic imidazolate framework-8 (ZIF-8) nanocrystals at 800 °C and 950 °C, respectively. Then, they were employed as a catalytic layer in the gas diffusion electrodes p-ZIF-n/Ni/CB (n = 800 °C or 950 °C, CB = acetylene black). The production rates of H2O2 are up to 1.18 mg h−1 cm−2 and 1.25 mg h−1 cm−2 for p-ZIF-800/Ni/CB and p-ZIF-950/Ni/CB, respectively. Noticeably, although p-ZIF-800 had a lower degree of graphitization the difference in catalytic activity between p-ZIF-800 and p-ZIF-950 is negligible. This can be construed as a higher total nitrogen and richer mesoporous structure in p-ZIF-800 than in p-ZIF-950. Under optimized conditions of an electrode spacing of 3 cm, a pH value of 6.5, and a current density of 7.5 mA cm−2, the H2O2 production rate of p-ZIF-800/Ni/CB in the “floating-cathode” cell is up to as high as 2.09 mg h−1 cm−2, which is about 3.3 times higher than that of the cell with the “submerged-cathode” under aeration and stirring. Also, the p-ZIF-800/Ni/CB cathode demonstrates remarkable stability, it maintains its structure without losing catalytic activity after 5 catalytic cycle experiments. These results indicate that the state-of-the-art pyrolysis-based nitrogen-doped porous carbon materials exhibit a high potential for the advanced electrocatalyst of H2O2 electrogeneration.