Abstract
ABSTRACTThe high porosity and uniform pore size provided by mesoporous oxide films offer interesting opportunities for MEMS devices that require low density and low thermal conductivity. This paper describes recent efforts at adapting mesoporous films for MEMS fabrication. Mesoporous SiO2 and Al2O3 films were prepared using block copolymers as the structure-directing agents, leading to films which were 70% porous and < 5 nm surface roughness. A number of etchants were investigated and good etch selectivity was observed with both dry and wet systems. Micromachining methods were used to fabricate cantilevers, micro bridges and membranes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.