Preparation of high-strength ceramsite from coal gangue and printing and dyeing sludge: Design strategy and modelling mechanism

Abstract

Disposal and harmless utilization of coal-based solid waste, industrial sludge, and other bulk industrial solid waste is a sustainable and economical approach. In this study, coal gangue and printing and dyeing sludge were recycled to reconstruct high-strength ceramsite using a simple and scalable method. The high silica and alumina contents in coal gangue provided a foundation for ceramsite preparation, and the iron oxide in the printing and dyeing sludge could reduce the sintering temperature. The optimal synthesis conditions were as follows: Coal gangue: printing and dyeing sludge = 40:60; sawdust content of 9mass%; sintering temperature of 1175 °C for 15 min; and preheating temperature of 400 °C for 10 min. The designed ceramsite exhibited high compressive strength of 27.26 MPa, low 1-h water absorption of 1.26%, and bulk and apparent densities of 998 and 1597 kg/m3, respectively; thus, it was categorized as high-strength ceramsite. In determining the modelling mechanism during the sintering process, the silicon and aluminum distributions on the ceramsite surface obtained under the optimal preparation conditions was highly consistent, forming a silicoaluminate that supported the ceramsite strength. Sawdust addition increased the pore structure of the ceramsite. The heavy metals contained in the raw materials were well-immobilized in the ceramsite, indicating that the prepared ceramsites were free from secondary contaminants. Use of bulk solid waste to prepare high-strength ceramsites is a feasible resourceful and harmless utilization method, which is of great significance for bulk solid waste disposal and reuse.