Preparation of Fe3AI based iron aluminides from elemental and prealloyed povvders

Abstract

Iron aluminides were prepared by a powder metallurgy process from elemental powders, mixtures ofprealloyed and elemental powders, and prealloyed powder. The sintering behaviour of various powders was studied using scanning electron microscopy, optical microscopy, and density measurement. It was found that sintering of elemental powder involved two distinct processes, i.e. alloying and densification, but sintering ofprealloyed powder involved densification alone. The addition of prealloyed powder to elemental powders was helpful in restraining the swelling of sintered samples, the degree of swelling of sintered samples being reduced as the amount of prealloyed powder increased. For samples made from Fe-25 at.-%Al prealloyed powder, remarkable shrinkage was measured after sintering at 1250°C for I h. Within the correct range, their density increased with sintering temperature and time, but prolonged sintering at high temperature resulted in the loss of aluminium and a two phase microstructure. The difference in sintering behaviour between the various powders was discussed on the basis of thermodynamics. MST/2020