Abstract
A simple approach for the preparation of core–shell microstructures with an anisotropic shape is proposed in which an Ag nanowire/polyurethane acrylate (AgNW/PUA) composite produced by inverted layer processing is used as a temporary template for the sequential electroless plating of a Cu metal core and Ni shell. Through careful optimization of the metallization conditions, a Cu@Ni core–shell microstructure with an anisotropic shape (i.e., an aspect ratio greater than five) is obtained, which can be easily detached from the template through simple sonication. This technique is therefore considered to be readily applicable to the fabrication of conductive fillers for use in composite structures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
