Abstract
A new method for the preparation of gas separation membranes in a one-step procedure is presented, where common, non-volatile solvents can be used in the polymer solution. It concerns contacting of a polymer solution with two successive nonsolvent baths, whereby the first bath initiates the formation of a dense top layer and the second bath gives the actual polymer precipitation. Membranes made by this method will have high gas selectivity and do not need any additional coating. The new technique was used to make polyethersulfone (PES) hollow fibres from solutions consisting of 35% (w/w) polymer and 10% glycerol in N-methylpyrrolidone (NMP). High selectivities were obtained when using glycerol or 1-pentanol as the first nonsolvent and water as the second one. For a feed gas of 25 vol.% of CO 2 in methane the intrinsic selectivity of PES [α (CO 2/CH 4) ≈ 50] was easily obtained, without the necessity of an additinal coating step. By a step-wise, liquid exchange removal of residual fluids in the fibres, an improvement in flux could be obtained. This was accompanied by a somewhat lower selectivity compared to that of directly air-dried fibres.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
