Abstract
In this work we report the preparation and evaluation of the mechanical characteristics of resin-bond composite abrasives using virgin and recycled alumina grains. The composite abrasives were made with phenolic resin as binder and as-received virgin and recycled alumina grains. Three different recycled alumina grains were studied: i) alumina from wood firing resin-bond abrasive tools; ii) alumina from wood firing vitrified-matrix abrasive tools; and iii) ground alumina from vitrified-matrix abrasive tools. The virgin alumina grains were employed in order to compare the mechanical performance of the prepared composite abrasive. The composition of alumina grains, analyzed by X-ray fluorescence spectroscopy revealed the recycled alumina grains have lower alumina content and higher concentration of silica in vitrified-matrix abrasives samples. The sand blast penetration tests have shown lower penetration depth in the virgin and the ground vitrified-matrix grains composites. The impact strength test results revealed its dependence on the alumina and silica content: samples with higher alumina content present the higher impact resistance whereas samples with higher silica content present lower impact strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.