Preparation and properties of transparent thermoplastic segmented polyurethanes derived from different polyols

Abstract

AbstractVarious segmented polyurethanes of different soft segment structure with hard segment content of about 50 wt% were prepared from 4,4′‐diphenylmethane diisocyanate (MDI), 1,4‐butanediol and different polyols with a Mn of 2000 by a one‐shot, hand‐cast bulk polymerization method. The polyols used were a poly(tetramethylene ether)glycol, a poly(tetramethylene adipate)glycol, a polycaprolactonediol and two polycarbonatediols. The segmented polyurethanes were characterized by gel permeation chromatography (GPC), UV‐visible spectrometry, differential scanning calorimetry (DSC), dynamic mechanical analysis (DMA), X‐ray diffraction, and their tensile properties and Shore A hardness were determined. The DSC and DMA data indicate that the miscibility between the soft segments and the hard segments of the segmented polyurethanes is dependent on the type of the soft segment, and follows the order: polycarbonate segments > polyester segments > polyether segments. The miscibility between the soft segments and the hard segments plays an important role in determining the transparency of the segmented polyurethanes. As the miscibility increases, the transparency of the segmented polyurethanes increases accordingly. The segmented polyurethanes exhibit high elongation and show ductile behavior. The tensile properties are also affected by the type of the soft segment to some extent. POLYM. ENG. SCI., 47:695–701, 2007. © 2007 Society of Plastics Engineers.