Preparation and properties of porous particles from trimethylolpropane trimethacrylate

Abstract

AbstractSpherical macroporous particles, intended for use as carrier particles in various types of column operations, were prepared by suspension and microsuspension polymerization of trimethylolpropane trimethacrylate (TRIM), in the presence of various amounts of porogenic agents (toluene or mixtures of toluene and isooctane). The texture and properties of the particles varied markedly with the amount and composition of the porogenic agent, and were also affected by the choice of suspension stabilizer. Macroporous particles were prepared, ranging in total pore volume from 0.4 to 3.6 cm3/g, and in specific surface area from 7 to >450 m2/g. All of the particles contained macropores, and except for those with very low specific surface area, contained a certain fraction of micropores (diameter <60 Å). The presence of micropores could be eliminated completely by decreasing the monomer concentration and increasing the isooctane content of the porogenic agent to 50 wt.‐%. Increasing the isooctane content also resulted in an increase in the total pore volume and a decrease in the tendency of the polymer matrix to swell in toluene. The effect on properties of particles by heat treatment at 130°C and by grafting poly(methyl methacrylate) onto the particles was also studied.The amount of unreacted double bonds of the particles could be varied by varying the polymerization temperature. The presence of easily accessible double bonds is important as they can be utilized for functionalization of the rigid macroporous particles.