Abstract
Abstract A new approach has been proposed to obtain high-temperature proton exchange membranes based on novel cross-linked porous polybenzimidazole (PBI). The cross-linked porous PBI membranes (CpPBI) were prepared by leaching out a low-molecular-weight compound dibutyl phthalate and mixing 4,4′-diglycidyl (3,3′,5,5′-tetramethylbiphenyl) epoxy resin as a cross-linker. The porous PBI membranes (pPBI) were also prepared for comparison. Compared with pPBI membranes, the mechanical properties and the chemical stability of CpPBI membranes were significantly improved. Both the uncross-linked and cross-linked membranes were doped with phosphoric acid, which may be used as proton exchange membranes for high temperature fuel cell. The doping level of all the pPBI membranes was higher than that of pristine PBI, thus leading to a higher proton conductivity. Especially the CpPBI-10 (with a cross-linker content of 10 wt.% and a porogen content of 50 wt.%) had a relative high proton conductivity of 0.046 S cm −1 at 200 °C, which is higher than some of the known porous PBI membranes measured under similar conditions. All the remarkable results of the epoxy-cross-linked porous PBI membranes indicated that the CpPBI membranes could be a suitable candidate for high temperature proton exchange membrane fuel cell (HT-PEMFC) applications.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
