Abstract
Foam extrusion of biodegradable polyester [poly(butylene adipate-co-terephthalate) (PBAT)] and its blends with maleated thermoplastic starch (MTPS) using a chemical blowing agent was performed. The effect of MTPS and percentage of chemical blowing agent on various foam properties is discussed. In general, an increased amount of PBAT in the foams improves the properties of the foams. The foam samples were characterized by measurements of density, expansion ratio, specific length, compressive strength, resiliency, moisture sorption, and imaging using digital light microscopy. Density, expansion ratio, and specific length measurements show that the best characteristics of lowest density, highest expansion ratio, and highest specific length are exhibited by the PBAT samples. The compressive strength and foam density exhibit a power-law relationship. Greater amounts of PBAT in the samples increase the resiliency and decrease the steady state weight gain during moisture sorption. All samples show regions of unfoamed material when only 3% chemical blowing agent is used, but when 5 and 7% chemical blowing agent is used, the samples exhibit cells throughout the matrix.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
