Abstract
Flexible strain sensors are widely used in the fields of personal electronic equipment and health monitoring to promote the rapid development of modern social science and technology. In this paper, silver nanowires (AgNWs) prepared via the polyol reduction method were used to construct a flexible strain sensor. The AgNWs/PDMS film was obtained by transfer printing using AgNWs as a conductive layer and polydimethylsiloxane (PDMS) as a flexible substrate. The morphology of AgNWs was characterized by SEM and TEM. The aspect ratio of the AgNWs was more than 700. The strain sensitivity factor of the sensor was 2.8757, with a good linear relationship between the resistance and the strain. Moreover, the strain sensor showed good response results in human activity monitoring and the LED lamp response test, which provides a new idea for the construction of flexible wearable devices.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
