Abstract
SmFeAsO0.7F0.3 polycrystalline bulk iron-based compound were prepared by one-step solid state reaction method at low sinter temperature. The aim was: to find the optimum preparing method for the compound and then to study its structural properties. The X-ray diffraction spectrum of the samples was analyzed using MAUD software. XRD measurements were used to characterize the crystal structure, phase purity, lattice parameters, unit cell volume and bonding angles and intervals of the samples. The results were compared with JCPDS reference pattern and the reports in the literatures, to ensure the accuracy of the synthesis. The XRD analyses revealed an increase in the phase purity above 80%, by lowering the sinter temperature down to 900 ºC. Also, the samples have a tetragonal crystal structure with P4/nmm symmetry, at room temperature. The SEM images show the samples are almost homogeneous with some porosity. The porosity decrease and the grain size grow by decreasing the sinter temperature. These results show the preparation of good quality samples at low temperature of 900 ºC compared to 1200 ºC which usually is used for preparation of this family of compound.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
