Preparation and characterization of ultra-thin amphiphobic coatings on silicon wafers

Abstract

Fluorine-based amphiphobic coatings have been widely used in commercial domestic utensils and textiles to repel water and oil contaminants. However, few reports from the literature survey have discussed the effects on amphiphobicity of the nano- to micro-scale surface features of such a coating. In this research thin amphiphobic epoxy coatings based on a mixture of bisphenol A diglycidyl ether, tetraethylorthosilicate (TEOS), and a particular alkoxy silane with fluorinated side chains (F-silane) are deposited on silicon wafers. Film amphiphobicity is characterized by the measurement of water and oil contact angles of the coating. Film morphology is revealed in the scanned images using atomic force microscopy. The deposited films free of F-silane are about 10nm thick. When a small amount of F-silane was firstly added, the water and oil contact angles of the deposited films jumped up to 107° and 69° respectively and then flattened out with increased F-silane. Water droplets gave an average plateau contact angle about 110°, while vegetable oil ones, 40°. It was noted that there is a dramatic decrease in the lyophobicity causing a reduction in contact angles. However, surface lyophobicity also depends on sub-microscopic surface structures. In addition, by increasing TEOS, it was shown that the formed silica sols or granules were helpful in enhancing the mechanical strength along with retaining the lyophobicity of the film.