Abstract
Breathable films were prepared based on linear low-density polyethylene (LLDPE), calcium carbonate (CaCO3), and aluminum (Al; 0, 2, 4, and 8 wt.%) using extrusion molding at a pilot scale. These films must generally be able to transmit moist vapor through pores (breathability) while maintaining a barrier to liquids; this was accomplished using properly formulated composites containing spherical CaCO3 fillers. The presence of LLDPE and CaCO3 was confirmed by X-ray diffraction characterization. Fourier-transform infrared spectroscopy results revealed the formation of Al/LLDPE/CaCO3 composite films. The melting and crystallization behaviors of the Al/LLDPE/CaCO3 composite films were investigated using differential scanning calorimetry. Thermogravimetric analysis results show that the prepared composites exhibited high thermal stability up to 350 °C. Moreover, the results demonstrate that surface morphology and breathability were both influenced by the presence of various Al contents, and their mechanical properties improved with increasing Al concentration. In addition, the results show that the thermal insulation capacity of the films increased after the addition of Al. The composite with 8 wt.% Al showed the highest thermal insulation capacity (34.6%), indicating a new approach to transform composite films into novel advanced materials for use in the fields of wooden house wrapping, electronics, and packaging.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.