Preparation and characterization of polyurethane–silica hybrid films

Abstract

PurposeThe paper aims to provide a facile approach to the synthesis of polyurethane–silica nanocomposites by introducing self-made aqueous silica sols with different particle sizes into polyurethane materials. This paper investigates the effects of the silica nanoparticles on the polyester polyol, as well as the physical properties and transmittance of the hybrid polyurethane coatings.Design/methodology/approachColloidal silica particles of different sizes were obtained using a sol–gel process and were then embedded into polyester polyol by in-situ polymerization. These polyester polyol–silica resins were synthesized using an azeotrope process, using xylene to remove the water generated in the system and present in the dispersion medium for the colloidal silica. The polyester polyol–silica resins were further cured using isocyanate trimers to form polyurethane–silica hybrid films.FindingsThe paper observed that the viscosity of the polyester polyol–silica nanocomposite resins increased and their appearance changed from transparent to ivory white as the particle size of the added silica was increased. It was found that increasing the hydroxyl content of the silica improved the film transmittance in the visible light region. However, the transmittance decreased sharply once the diameter of the silica particles reached 100 nm.Research limitations/implicationsBecause of the limitation of experimental conditions, some performances have not been tested. Therefore, researchers are encouraged to conduct further tests.Practical implicationsThe paper provides a method of preparing hybrid polyurethane film by using silica; the results indicate that the introduction of nano-silica can improve the wear resistance and glass transition temperature of polyurethane coatings.Originality/valueThe results obtained in this study will be extremely useful to enhance the understanding of organic–inorganic hybrid materials.