Abstract

The water soluble peptide, melittin, isolated from bee venom and composed of twenty-six amino acids, was encapsulated in poly ( dl-lactic acid, PLA) and poly ( dl-lactic-co-glycolic acid, PLGA) microspheres prepared by a multiple emulsion [(W 1 / O)W 2] solvent evaporation method. The aim of this work was to develop a controlled release injection that would deliver the melittin over a period of about one month. The influence of various preparation parameters, such as the type of polymer, its concentration, stabilizer PVA concentration, volume of internal water phase and level of drug loading on the characteristics of the microspheres and drug release was investigated. It was found that the microspheres of about 5 μm in size can be produced in high encapsulation (up to 90%), and the melittin content in the microspheres was up to 10% (w/w). The drug release profiles in vitro exhibited a significant burst release, followed by a lag phase of little or no release and then a phase of constant melittin release. The type of polymer used was a critical factor in controlling the release of melittin from the microspheres. In this study, the rate of peptide release from the microspheres correlated well with the rate of polymer degradation. Moreover, melittin was released completely during the study period of 30 days, which agreed well with the polymer degradation rate.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.