Preliminary investigation fo the non-linear response of image intensifiers used for gamma-ray imaging

Abstract

Image intensifiers combined with columnar scintillators have found application in x-ray and gamma-ray, biomedical imaging and other fields. In scintillator imaging, hundreds or thousands of optical photons can illuminate the faceplate of the image intensifier in a small area, essentially simultaneously. This is a situation not found in the typical design application for an image intensifier, night vision or low-light-level imaging. Microchannel plates (MCPs) are known to exhibit gain saturation that could result in non-linear signal response in scintillator imaging, limiting quantitative measurement capabilities. A calibrated LED photon source was developed that can provide a known average number of photons per unit area in a small spot size, similar to that seen due to a gamma-ray interaction in a BazookaSPECT imager. A BazookaSPECT imager is composed of a columnar scintillator and an image intensifier, with output light optically imaged onto a CCD camera. The calibrated source was used to investigate gain-saturation effects for two Proxivision, GmbH image intensifiers, a single-stage BV 2583 EZ and a two stage BV 2583 QZ-V 100N in a BazookaSPECT imaging configuration. No gain saturation was found for the single-stage image intensifier up to more than 100 optical photons per microchannel, but significant gain-saturation non-linearities were measured in the two-stage image intensifier at high gains for >12 optical photons per microchannel. Implications for scintillator imaging using such systems are discussed.