Preferential Oxidation of CO in H2 Stream on Au/TiO2 Catalysts: Effect of Preparation Method

Abstract

A series of Au/TiO2 catalysts were prepared by either photodeposition or deposition−precipitation methods. The catalysts were characterized by inductively coupled plasma-mass spectrometry (ICP-MS), X-ray diffraction (XRD), transmission electron microscopy (TEM), and X-ray photoelectron spectroscopy (XPS). The catalytic performance of these catalysts was investigated by preferential oxidation of carbon monoxide in a hydrogen stream. A high gold dispersion and narrow size distribution was obtained for Au/TiO2 catalysts prepared by both photodeposition or deposition−precipitation methods. The photodeposition method facilitates the preparation of gold particles as small as 1.5 nm on the support, whereas in the deposition−precipitation method, the gold particles were found to be around 2−3 nm. The catalyst prepared by the photodeposition method showed higher CO conversion and CO selectivity than those prepared by the deposition−precipitation method. The selectivity of CO reacting with O2 decreased with increasing reaction temperature due to H2 competing with CO at high temperatures. Au/TiO2 catalysts prepared by the photodeposition method showed relatively higher CO selectivity below 65 °C when compared with the deposition−precipitation method. The differences in activity could be attributed to the difference in chemical state of gold particles and the particle size of gold. The catalyst prepared by photodeposition had a smaller particle size (1.5 nm). It had higher CO conversion at low temperature (<50 °C). However, the CO conversion and CO selectivity is low between 50 and 100 °C.