Abstract
Abstract Additive manufacturing (AM) method has attracted huge interest in the past decade due to its ability in building complicated geometries with a much lower cost than conventionally produced parts. In AM, the final mechanical properties can be controlled by the AM process parameters. In other words, the AM process parameters control the amount of energy that is transferred into the powder and consequently the resulting microstructure. In this study, the correlation between melt pool geometry and mechanical properties of selective laser melted (SLM) Ti–6Al–4V samples is investigated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
