PREDICTION OF WORKING LOAD DISPLACEMENTS UNDER PLATE LOADING TESTS FROM SEISMIC STIFFNESS MEASUREMENTS

Abstract

A study was conducted to evaluate the feasibility of compacting unbound aggregate base courses in thicker lifts than currently permitted by state departments of transportation (DOTs). At present, the majority of states allow a maximum lift thickness of 8 inches or less. This project constructed and tested full-scale test section using a variety of material types. Two test pads were constructed in an aggregate quarry in Texas utilizing crushed limestone. Three crushed granite test sections were built as part of a road widening project in Georgia, and two test pads were constructed of uncrushed and partially crushed gravel with loess fines at a gravel production facility near Memphis, Tennessee. Single-lift thicknesses varied from 6 inches to 21 inches. Moisture contents and densities were evaluated using the Nuclear Density Gauge (NDG). Nondestructive seismic testing, using the Spectral-Analysis-of-Surface-Waves (SASW) technique, was used to evaluate stiffness profiles within the compacted lifts. Plate load tests were conducted on the surface of the crushed limestone test pads by means of the Rolling Dynamic Deflectometer specially modified for this fixed site application. Low frequency cyclic loads were applied to determine axial stiffness under transient working loads of varying magnitude. The base courses were tested at two moisture contents. The results were evaluated and compared with small strain seismic tests results. Strain amplitudes in the plate load tests led to a 5% to 25% reduction in measured stiffness as compared to the seismic results.